#HARBOR FREIGHT FLUX CORE WELDER INSTALL#

I don't know how good yours is but I would say it'd be best for sheetmetal and pickup a used 220 stick welder for 50-100 bucks.

it's even survived being loaned out to friends with no failure or bad remarks. Merry Christmas to all celebrating today. The miller was $550 about 12 years ago and I've gone through about a dozen spools of wire on it. Harbor Freight 90amp Flux-core Welder- Teardown Posted by FenderBender on 25 Dec, 2012 19:54.

#HARBOR FREIGHT FLUX CORE WELDER INSTALL#

I used the miller 135 to weld the mount for my 6,000 lb winch to the nose of my car trailer and also used it to install new suspension by the side of the road on the trailer after the original failed. The penetration on up to 1/4' is excellent after a half inch of bead but to get started with good penetration, I opted to preheat with the torch just to be safe. This is from when I subframed my 76 f250 2x supercab with 4x4 suspension from my 77 f150 4x4 A metal stud construction company I worked for started out with the cheapest and tried everything from the bottom up and only the millers lasted. Harbor freight has the chicago electric 98871 90 amp flux wire welder for a low. This was about as much as my miller 135 could tackle.

Harbor freight flux core welder